Skip to content
Workouts

Glossary

Strength training glossary

30 terms you will meet in our plans and guides: RPE, RIR, volume, splits, deloads and more. Each one has a one-line definition, how we use it in practice and a worked example.

0–9

1RM (One-Rep Max)
Your 1RM, or one-rep max, is the heaviest weight you can lift once with good form on a given exercise; it is used to set training loads as percentages.

A

AMRAP (As Many Reps As Possible)
AMRAP means as many reps (or rounds) as possible: a set or a timed block where you keep going until you cannot complete another clean rep or the clock runs out.

B

Bro Split
A bro split is a five-day routine that trains one muscle group per day, typically chest, back, shoulders, legs and arms, so each muscle is worked once a week.

C

Calorie Deficit
A calorie deficit means eating fewer calories than your body burns in a day, so it draws on stored fat for the difference; it is the only way body fat is lost.
Compound Exercise
A compound exercise moves two or more joints and trains several muscle groups at once, such as a squat, deadlift, bench press, row or overhead press.

D

Deload
A deload is a planned easy week of training, usually at half the sets or 50–60% of the weight, that clears accumulated fatigue so progress can resume.
DOMS (Delayed Onset Muscle Soreness)
DOMS is the muscle soreness that appears 12–72 hours after unfamiliar or hard exercise, especially exercise with a big lowering phase, and fades within a few days.
Double Progression
Double progression means adding reps at a fixed weight inside a rep range, then adding weight and restarting at the bottom of the range once every set hits the top.
Drop Set
A drop set is one set taken close to failure, after which you immediately lower the weight by 20–30% and keep going, once or several times, with no rest.

E

EMOM (Every Minute on the Minute)
EMOM means every minute on the minute: you do a fixed number of reps at the top of each minute and rest for the time that remains, for a set number of minutes.

F

Full-Body Split
A full-body split trains every major muscle group in each session, usually two to four times a week, instead of dividing the body across different days.

H

Hypertrophy
Hypertrophy is the growth of muscle fibres in size, which is what 'building muscle' means physiologically and the main goal of muscle-gain training.

I

Isolation Exercise
An isolation exercise moves one joint and targets one main muscle, such as a biceps curl, leg extension, lateral raise or calf raise.

M

Macros (Macronutrients)
Macros are the three macronutrients that supply calories: protein and carbs at 4 kcal per gram, fat at 9; counting macros means setting a daily gram target for each.
MET (Metabolic Equivalent of Task)
A MET is a unit of energy cost: 1 MET is the energy you use sitting quietly, and an activity rated 6 METs burns six times that for as long as you do it.
Mind-Muscle Connection
Mind-muscle connection is deliberately focusing attention on the target muscle while lifting, so it does more of the work; it helps most on isolation exercises.

P

Progressive Overload
Progressive overload means gradually increasing the demand on your muscles over time, through more weight, reps, sets or harder variations, so they keep adapting.
Push/Pull/Legs (PPL)
Push/pull/legs is a split that trains pushing muscles (chest, shoulders, triceps) one day, pulling muscles (back, biceps) the next and legs on the third.

R

Rep Range
A rep range is the span of repetitions prescribed for a set, such as 8–12, instead of a fixed number, so you can add reps at the same weight before adding load.
RIR (Reps in Reserve)
RIR is the number of extra reps you could still have done when a set ended: 0 RIR is failure, 2 RIR means you stopped two reps short of it.
RPE (Rate of Perceived Exertion)
RPE is a 1–10 scale for how hard a set felt: 10 means no more reps were possible, 9 means one rep was left, 8 means two reps were left.

S

Superset
A superset is two exercises performed back to back with little or no rest between them, followed by a normal rest before the next pair.

T

TDEE (Total Daily Energy Expenditure)
TDEE is the total number of calories you burn in a day (resting metabolism, digestion, daily movement and exercise); eat below it to lose fat, above it to gain.
Tempo
Tempo is the speed of each phase of a rep, written as four numbers in seconds, such as 3-1-1-0: lowering, pause at the bottom, lifting, pause at the top.
Time Under Tension (TUT)
Time under tension is how long a muscle works against load during a set, from the first rep to the last; it is one way of describing a set's total work.
Training to Failure
Training to failure means continuing a set until you cannot complete another rep with good form; it is 0 reps in reserve or RPE 10.
Training Volume (Hard Sets)
Training volume is how much work a muscle gets per week, counted in our plans as hard sets (sets within 1–3 reps of failure), with 10–20 per muscle as the target.

U

Unilateral Training
Unilateral training works one arm or one leg at a time, as in lunges, split squats, single-arm rows and single-leg deadlifts, instead of both limbs together.
Upper/Lower Split
An upper/lower split alternates sessions for the upper body (chest, back, shoulders, arms) and the lower body (legs, glutes), usually four days a week.

W

Warm-Up Ramp Sets
Ramp sets are two to four progressively heavier, low-rep sets of an exercise done before the first working set, to prepare the joints and rehearse the movement.

Want the longer version?

Our guides cover the same ideas in depth: how to start, how to pick a split, how to progress and when to deload.

Browse the guides